Bound for Glory Angel Pin

Glue the face (11mm pearl) to the halo (15mm earring dangle).

Using round nose pliers, make an open spiral at the end of each of the four 20-gauge wires, making sure the open spirals are different sizes.
Line up the straight ends of the 4 wires, so that the ends are parallel. Make a bundle at this end, using half-round wire to wrap 4 or 5 times to show. Trim the 4 wires to be nearly flush with the wrap wire.

Attach the 3 jump rings to the open spirals for stability. You've completed the angel's skirt.

Glue the angel's skirt to the front of your wings with E6000 glue. Wait at least 1-1/2 hours for the glue to dry before going on to the next step.

Glue the halo-face combination to the front of the wings, just above the skirt. Allow glue to dry.

Glue the bow to the bundle wrap wire for a finished look. Allow glue to dry.

Glue the flat part of the tie tac to the back of the wings, in the center. Let the glue dry.

Wear and enjoy!